cutting glass
- Thread starter noone
- Start date
Awesome.
One tip: When the LFS near me drills holes they buld an epoxy dam around the area they're gonna drill and just put a small amount of anti-freeze inside it.
It should work fine with water as well.
That way you don't have to worry about clamping a hose off to keep things cooled down while you drill.
B
One tip: When the LFS near me drills holes they buld an epoxy dam around the area they're gonna drill and just put a small amount of anti-freeze inside it.
It should work fine with water as well.
That way you don't have to worry about clamping a hose off to keep things cooled down while you drill.
B
I have drilled 4 or 5 tanks with the same method and another bit that I found useful was a diamond drum sander. It seems like I am kinda shy about drilling the hole too big and I end up needing to open it up a little and the drum sander is perfect for the job, it only takes a few seconds to knpck out any rough spots and open the hole right up. Here is a link to the drum sanders that I use: http://www.harborfreight.com/cpi/ctaf/D ... mber=32157 . HTH, Skip
mikeguerrero
Active Member
Que Padre,
Me gusta como nos ensenyas tus metedos en tu pais de MEXICO.
Mike
Me gusta como nos ensenyas tus metedos en tu pais de MEXICO.
Mike
smoke eater
New Member
Vegatable oil works great and it is easier to clean than antifreeze.